Electron beam sterilization
Nowadays, an automation technology confront with a difficulty in constructing equipments for applications in the highvoltage side. Programmable logic controllers (PLC) and other electronic components for example have to be protected against overvoltages and in the case of electron beam systems al...
Saved in:
| Main Author: | |
|---|---|
| Format: | Thesis |
| Language: | English |
| Published: |
2004
|
| Subjects: | |
| Online Access: | http://umpir.ump.edu.my/id/eprint/2186/1/NOR_RUL_HASMA_BINTI_ABDULLAH.PDF |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | Nowadays, an automation technology confront with a difficulty in constructing
equipments for applications in the highvoltage side. Programmable logic controllers
(PLC) and other electronic components for example have to be protected against overvoltages
and in the case of electron beam systems also against x-rays. This is expensive
and not easy to achieve but possible. The project is consists of three stages. The first
stage demonstrates, through experimental on two parts of circuit boards inside the
highvoltage deck of electron beam accelerator unit; filament control circuit board and
beam control circuit boards. In these circuit boards, an analog signal flow from low
/ voltage sides via optical link cable to the ground and transmitted to the highvoltage side.
The calibrations are made to ensure it's operated correctly. The second stage is to
generate a new method of filament control and beam control circuit by constructing a
Programmable Logic Controller (PLC) using the STEP 7- Micro/W1N32 and SIMATIC
WinCC software provided by SIEMENS AG. It is capable to operate under a
highvoltage potential. It uses a PROFJBUS technology as the central connecting link for
digital signal flow in the system. The advantages of digital solution are the speed of data
transmitting in both directions are faster and better signal to noise ratio (SNR) than
analog solution. Finally, as the circuits in both projects are operated under a highvoltage
potential, thus there will be a conflict with the transient voltage upon the components,
equipments and cables installed in the circuits. Therefore, in the third stage, one circuit
protection is created and examined to show transient voltage fault investigation methods
and possible solutions. At the end, this project is attempted to expand the automation
technology in highvoltage area and support future development in this area |
|---|