Enhancement of low velocity impact properties of bamboo/glass fibre hybrid composites using carbon nanotubes for aerospace structural applications
Recently, polymer nanocomposites have been fabricated using carbon nanotubes (CNTs) as reinforcement nanofillers. However, the effect of incorporating CNT into hybrid polymer composites with natural fibre is not clear. This study investigated the effect of using multi-walled carbon nanotube mate...
Saved in:
| Main Author: | |
|---|---|
| Format: | Thesis |
| Language: | English |
| Published: |
2018
|
| Subjects: | |
| Online Access: | http://psasir.upm.edu.my/id/eprint/77279/1/FK%202018%20177%20ir_2.pdf |
| Tags: |
Add Tag
No Tags, Be the first to tag this record!
|
| Summary: | Recently, polymer nanocomposites have been fabricated using carbon
nanotubes (CNTs) as reinforcement nanofillers. However, the effect of
incorporating CNT into hybrid polymer composites with natural fibre is not
clear. This study investigated the effect of using multi-walled carbon
nanotube material (MWCNT) as the nanofiller in bamboo/glass hybrid
composites on the mechanical properties (tensile and flexural) and impact
properties. Composites containing various weight fractions of CNTs (0.1
wt.%, 0.3 wt.%, 0.5 wt.%, and 1.0 wt.%) were produced thus compared with
the control hybrid composites in tensile and flexural properties. Meanwhile,
only 0.5 wt.% CNT was compared with the control hybrid composites in low
velocity impact (LVI) test at various energy levels from 7J to 35J and then
subjected to the compression after impact (CAI) test for further analysis. The
hybrid composites were prepared with epoxy resin by hand lay-up method.
The experimental results revealed an increase in the tensile strength of the
composites with the addition of up to 0.5 wt.% CNTs (+7.73% over the
control hybrid). However, beyond this value, i.e., with 1.0 wt.% CNT
additives, the composite strength showed a remarkable decrease (-36.8%
compared with the control hybrid). The decrement supported with Field
Emission Scanning Electron Microscopy (FESEM). Moreover, introducing
CNTs into hybrid composites resulted reduced the flexural properties with
increasing weight fractions as low as 8.45% compared with the controls.
Besides that, LVI showed the enhancement of CNTs in hybrid composites contributed towards the improvement in impact resistance (9.21% less in
energy absorbed and maximum of +36.2% in term of peak force compared to
the control hybrid) and CAI strength up to 23.7% corresponding to the
controls. In sum, the tensile properties increased with the addition of up to
0.5 wt.% CNTs and increased the impact properties including CAI properties
when introducing CNTs into the hybrid composites, but there was a decrease
in the flexural properties. Hence, this thesis gives better understanding on
the newly-hybridisation material’s mechanical properties. |
|---|