Design And Verification Of An Oscillating Wear Tester To Stimulate The Piston-Cylinder Tribology In Internal Combustion Engines

Design And Verification Of An Oscillating Wear Tester To Stimulate The Piston-Cylinder Tribology In Internal Combustion Engines

An Oscillating Wear Tester (OWT) was built to simulate the piston-cylinder tribology in internal combustion engines. This tester consists of load system, motion system and frictional force measurement system. It operates at a speed of 10-1500 rpm. AL 380-0-F die casting alloy used as blank (cylinder...

Saved in:

书目详细资料
主要作者:	Al-Tmeemi, Bhaa Alden Hussein Ali
格式:	Thesis
语言:	English
出版:	2011
主题:	TJ1-1570 Mechanical engineering and machinery
在线阅读:	http://eprints.usm.my/41642/1/BHAA_ALDEN_HUSSEIN.pdf
标签:	添加标签没有标签, 成为第一个标记此记录!

相似书籍

Tribological study of nanoparticles enriched bio-based lubricants for engine piston ring-cylinder interaction /
由: Gulzar, Mubashir
出版: (2017)

Investigation on tribological (wear) properties of aluminum-silicon piston alloy /
由: Tuti Yasmin Alias
出版: (2003)

Effect Of Electroless Plating On Wear And Surface Friction Of Alsi Cylinder Liner By Mukridz Bin Md Mohtar Effect Of Electroless Plating On Wear And Surface Friction Of Alsi Cylinder Liner
由: Mohtar, Mukridz Md
出版: (2012)

A study of the wear of piston seals and cylinder in a reciprocating water pump /
由: Ng, Wah Lok
出版: (1989)

Development of a pin-on-disk tester for the tribological study of magnetic disk media /
由: Wu, Siong Wei
出版: (1998)

Effect Of Supercharging And Turbocharging In A Multi Cylinder Low Speed Spark Ignition Engine Fuelled By Producer Gas
由: Mohd Shafie, Mohd Saiful Aizat
出版: (2015)

Experimental Studies Of Spray And Combustion Characteristics Of Biomass Derived Fuels In A Constant Volume Combustion Chamber
由: Soid, Shahril Nizam Mohamed
出版: (2013)

Experimental And Computational Study Of Flow Over A Rotating Cylinder With Surface Roughnes
由: SEMAN, MOHAMAD TARMIZI ABU
出版: (2016)

Premixed Flameless Combustion Of Producer Gas In A Cyclone Combustor
由: Chanphavong, Lemthong
出版: (2019)

The behaviour of flow around an oscillating cylinder in mean flow /
由: Tan, Kok Tin
出版: (1986)

Ultrasound device tester
由: Mohd Nordin, Murni Norestri
出版: (2009)

In Process Roughness Measurement And Tool Nose Radius Wear Assesment In Finish Turning Using Machine Vision
由: Balasundaram, Mohan Kumar
出版: (2017)

Study On The Effect Of Tool Nose Wear On Surface Roughness And Dimensional Deviation Of Workpiece In Finish Turning Using Machine Vision.
由: Haghighi, Hamidreza Shahabi
出版: (2008)

Effect of heat treatment on hardness and wear properties of an aluminum alloy of motorcycle piston
由: Mohd Fizam, Hj. Zainon

Analysis of pre-combustion chamber in single cylinder engine performance with natural gas fuel
由: Muhamad Tajuddin, Khairil Amri
出版: (2024)

Tribology study on vane coated cylinder of a rotary compressor /
由: Lenny Yusnita Mustapah
出版: (2014)

Hybrid fuzzy adaptive control strategies on double acting pneumatic cylinder rod-piston positioning
由: Mohd Iskandar Putra, Azahar
出版: (2020)

Numerical modeling and analysis of flow around stationary oscillating circular cylinder /
由: Khan, Niaz Bahadur
出版: (2018)

Stratified-charge two-stroke stepped-piston engine
由: Abdul Latiff, Zulkarnain
出版: (2011)

Performance & Emission Characteristic Of Emulsified Biofuel Application In Diesel Engine
由: Hamid, Mohd Fadzli
出版: (2017)

Determination Of Frequency Dependent Global Dynamic Properties Of Engine Mount
由: OOI , LU EAN
出版: (2004)

Determination Of Frequency Dependent Global Dynamic Properties Of Engine Mount
由: Ooi, Lu Ean
出版: (2014)

Experimental investigation of four throttle system in four cylinder internal combustion engine / Syed Muslim Syed Kamaruddin
由: Syed Kamaruddin, Syed Muslim
出版: (2006)

Development of a spark ignition free-piston engine generator
由: Mohd Razali, Hanipah
出版: (2015)

Port Injection Of Biomass Producer Gas From Downdraft Gasifier In A Diesel Engine
由: Hassan, Suhaimi
出版: (2011)

Air Fuel Mixing Modeling For Direct And Transfer Port Injection In Two Stroke Engine
由: Tan, Yee Hern
出版: (2013)

Design And Performance Analysis Of A Small Two-Stroke Direct Injection Diesel Engine.
由: Loh, Jian Haur
出版: (2011)

Simulation And Experimental Studies Of Intake And Exhaust Tuning For Automotive Engine Low-End Torque Enhancement
由: Khoo, Aik Soon
出版: (2014)

Simulation And Experimental Studies Of Intake And Exhaust Tuning For Automotive Engine Low-End Torque Enhancement
由: Khoo, Aik Soon
出版: (2014)

Development Of Variable Valve Timing Mechanism For Compressed Air Engine
由: Ahmad, Fathul Hazrimy
出版: (2019)

Investigation of inclusion casting, sand blasting and embossing methods to prepare engine cylinder bore surface for frictional and wear improvement
由: Kong, Chung Hwa
出版: (2021)

An unsteady wake-source model for flow past in-line oscillating circular cylinder and flat plate /
由: Wong, Sin Ching
出版: (1993)

Comparative study of nanoparticles and alcoholic fuel additives with optimized synthesis of palm-sesame biodiesel using tribological and internal combustion engine testing /
由: Abbas, Muhammad Mujtaba
出版: (2021)

Endurance tester (switch) computer aided / Israil @ Saiful Jibar
由: Jibar, Israil @ Saiful
出版: (1997)

Development Of Reverse Engineering System For Generating 3d Cad Body From 2d Image_875008757
由: Abdulqawi, Nur Ilham Aminullah
出版: (2017)

Numerical Investigation On The Effects Of Geometrical Parameters On Film Cooling Performance
由: Ali, Amir Hussein
出版: (2013)

The evaluation of software requirement specifications for software testers / Rifhan A Rahim
由: A Rahim, Rifhan
出版: (2017)

Analysis Of Piston Secondary Motion
由: Tan, Yeow Chong
出版: (2014)

The effect of fuel injection pressure and in cylinder temperature on igniton delay, combustion performance and emission
由: Mohmad Jaat, Md Norrizam
出版: (2020)

Experimental investigation of top compression piston ring morphology for hydrogen enrichment diesel engine
由: Md. Nafiah, Mohd Rozaini
出版: (2016)

Services hosted by the Perpustakaan Sultan Abdul Samad, Universiti Putra Malaysia with Cooperation MySyL Group