2 dimension woven kenaf reinforced unsaturated polyester composite
In recent years, natural fiber from vegetables such as hemp, sisal, ramie, jute and kenaf has been recognized and studied by many researchers due to its potential as an alternative material for synthetic fibers in composite application. Kenaf fiber is a potential reinforced material for compos...
Saved in:
| 主要作者: | |
|---|---|
| 格式: | Thesis |
| 語言: | English English English |
| 出版: |
2014
|
| 主題: | |
| 在線閱讀: | http://eprints.uthm.edu.my/1724/1/24p%20MOHD%20PAHMI%20SAIMAN.pdf http://eprints.uthm.edu.my/1724/2/MOHD%20PAHMI%20SAIMAN%20COPYRIGHT%20DECLARATION.pdf http://eprints.uthm.edu.my/1724/3/MOHD%20PAHMI%20SAIMAN%20WATERMARK.pdf |
| 標簽: |
添加標簽
沒有標簽, 成為第一個標記此記錄!
|
| 總結: | In recent years, natural fiber from vegetables such as hemp, sisal, ramie, jute and
kenaf has been recognized and studied by many researchers due to its potential as an
alternative material for synthetic fibers in composite application. Kenaf fiber is a
potential reinforced material for composite due to its acceptable properties and
supported by the development in Malaysian Kenaf cultivation. Previous studies have
demonstrated that Kenaf fibers were recognized in several applications such as
automotive component, panel board, packaging, filter material and industrial paper.
However, the reinforcement of the fibers is in random, unidirectional and particle
form. Therefore, this research is focusing on the composites woven structural
preform from the kenaf fiber assisted with the use of internal geometry modeling for
optimization. The effect of primary parameters, which are the yarns properties, the
fabric count and the weave designs were evaluated on it physical and mechanical
properties. Different woven design preform (plain, twill 4/4, satin 8/3 and basket 4/4)
were fabricated using floor loom and infused with unsaturated polyester resin using
vacuum infusion process. The mechanical properties of the composites were
measured and showed that satin 8/3 has highest tensile strength of 39MPa and Plain
has highest tensile modulus of 2.63GPa, with flexural strength and impact strength of
48MPa and 29kJ/m2
respectively. The use of VIP and UPE show a good infusion of
resin between intra yarns but need much lower viscosity on the UPE for inter yarns.
The used of 5% sodium hydroxide solution with the application of tension during the
treatment enhanced the composite strength of 12%. The stacking sequence and
orientation of 0⁰
,45⁰,0⁰ of the laminate composite had increased the flexural strength
and impact strength of 73MPa and of 82MPa respectively. It is recommended to use
a plain and satin structure for better infusion in vacuum infusion process |
|---|