Effectiveness of synthetic jet actuators for separation control on an airfoil

The aerodynamic performance of an airfoil could be improved by controlling flow separation using active flow control techniques. In this study, a synthetic jet actuator (SJA) based on piezoelectric diaphragm has been developed. The selection of the SJA was due to their advantages in being lightweigh...

Full description

Saved in:
Bibliographic Details
Main Author: Dahalan, Md. Nizam
Format: Thesis
Language:English
Published: 2017
Subjects:
Online Access:http://eprints.utm.my/id/eprint/79371/1/MdNizamDahalanPFKM2017.pdf
Tags: Add Tag
No Tags, Be the first to tag this record!
id my-utm-ep.79371
record_format uketd_dc
spelling my-utm-ep.793712018-10-14T08:45:00Z Effectiveness of synthetic jet actuators for separation control on an airfoil 2017 Dahalan, Md. Nizam TJ Mechanical engineering and machinery The aerodynamic performance of an airfoil could be improved by controlling flow separation using active flow control techniques. In this study, a synthetic jet actuator (SJA) based on piezoelectric diaphragm has been developed. The selection of the SJA was due to their advantages in being lightweight, no external air supply required, simple system assembly, fast time response, low power consumption, easy installation, low cost and relatively small in size. Basically, the performance of the SJA depends on the specification and configuration of jet orifice, cavity, and oscillating membrane. The parameters studied include waveform signal, frequency, voltage, cavity and orifice physical characteristics. Final design and geometry of the SJA were determined based on these parameters. The SJA design with the best performance has been developed to generate sufficient air jet velocity to control flow separation. The experimental results measured by a hot-wire anemometer show that the maximum jet velocity obtained by the SJA with circular and slot orifice were 41.71 m/s and 35.3 m/s at an applied frequency of 900 Hz and 1570 Hz respectively. Next, the selected SJA was embedded into the wing with NACA 0015 airfoil and placed at 12.5% chord from the leading edge. Wind tunnel testing was conducted for stationary and oscillating airfoil conditions, with and without the SJA. The unsteady aerodynamic loads were calculated from the surface pressure measurements of 30 ports along the wing chord for both upper and lower surfaces. The airfoil was tested at various angles of attack at a free-stream velocity of up to 35 m/s corresponding to a Reynolds number of 1.006 x 106. Specifically for an oscillating airfoil, the reduced frequency, k, was varied from 0.02 to 0.18. The results of an airfoil with SJA showed that the CLmax and stall angle increased up to 13.94% and 29% respectively. Based on the results obtained, the SJA has an excellent capability to control the flow separation with delaying the stall angle, increasing the maximum lift, reducing the drag and delaying the intense nose down pitching moment. 2017 Thesis http://eprints.utm.my/id/eprint/79371/ http://eprints.utm.my/id/eprint/79371/1/MdNizamDahalanPFKM2017.pdf application/pdf en public phd doctoral Universiti Teknologi Malaysia, Faculty of Mechanical Engineering Faculty of Mechanical Engineering
institution Universiti Teknologi Malaysia
collection UTM Institutional Repository
language English
topic TJ Mechanical engineering and machinery
spellingShingle TJ Mechanical engineering and machinery
Dahalan, Md. Nizam
Effectiveness of synthetic jet actuators for separation control on an airfoil
description The aerodynamic performance of an airfoil could be improved by controlling flow separation using active flow control techniques. In this study, a synthetic jet actuator (SJA) based on piezoelectric diaphragm has been developed. The selection of the SJA was due to their advantages in being lightweight, no external air supply required, simple system assembly, fast time response, low power consumption, easy installation, low cost and relatively small in size. Basically, the performance of the SJA depends on the specification and configuration of jet orifice, cavity, and oscillating membrane. The parameters studied include waveform signal, frequency, voltage, cavity and orifice physical characteristics. Final design and geometry of the SJA were determined based on these parameters. The SJA design with the best performance has been developed to generate sufficient air jet velocity to control flow separation. The experimental results measured by a hot-wire anemometer show that the maximum jet velocity obtained by the SJA with circular and slot orifice were 41.71 m/s and 35.3 m/s at an applied frequency of 900 Hz and 1570 Hz respectively. Next, the selected SJA was embedded into the wing with NACA 0015 airfoil and placed at 12.5% chord from the leading edge. Wind tunnel testing was conducted for stationary and oscillating airfoil conditions, with and without the SJA. The unsteady aerodynamic loads were calculated from the surface pressure measurements of 30 ports along the wing chord for both upper and lower surfaces. The airfoil was tested at various angles of attack at a free-stream velocity of up to 35 m/s corresponding to a Reynolds number of 1.006 x 106. Specifically for an oscillating airfoil, the reduced frequency, k, was varied from 0.02 to 0.18. The results of an airfoil with SJA showed that the CLmax and stall angle increased up to 13.94% and 29% respectively. Based on the results obtained, the SJA has an excellent capability to control the flow separation with delaying the stall angle, increasing the maximum lift, reducing the drag and delaying the intense nose down pitching moment.
format Thesis
qualification_name Doctor of Philosophy (PhD.)
qualification_level Doctorate
author Dahalan, Md. Nizam
author_facet Dahalan, Md. Nizam
author_sort Dahalan, Md. Nizam
title Effectiveness of synthetic jet actuators for separation control on an airfoil
title_short Effectiveness of synthetic jet actuators for separation control on an airfoil
title_full Effectiveness of synthetic jet actuators for separation control on an airfoil
title_fullStr Effectiveness of synthetic jet actuators for separation control on an airfoil
title_full_unstemmed Effectiveness of synthetic jet actuators for separation control on an airfoil
title_sort effectiveness of synthetic jet actuators for separation control on an airfoil
granting_institution Universiti Teknologi Malaysia, Faculty of Mechanical Engineering
granting_department Faculty of Mechanical Engineering
publishDate 2017
url http://eprints.utm.my/id/eprint/79371/1/MdNizamDahalanPFKM2017.pdf
_version_ 1747818212227022848