-
1by Mohammad Diab, Nateg“....% on the microstructure and mechanical properties of hypereutectic Al-Si and hypoeutectic Al-Mg alloys. The microscopic...”
Published 2015
Get full text
Thesis -
2by Haghighati, Razieh“... in Masjid al-Haram yard, Makkah, Saudi Arabia. It consists of seven counterclockwise circulations around...”
Published 2012
Get full text
Thesis -
3by A. Asmael, Mohammed Bsher“...-Al-Si cast alloy has been conducted. The investigation has as main objectives to investigate...”
Published 2009
Get full text
Thesis -
4by Moftah Saeid, Fareg Saeid“... that PCD tools are important in cutting this hard Al-Si alloy of reduced machinibility. The lowest cutting...”
Published 2007
Get full text
Thesis -
5by Tan, Ming Jiun“... on the isothermal oxidation behavior of Ti-Al based intermetallics. High temperature oxidation test was carried out...”
Published 2008
Get full text
Thesis -
6by Mohd. Sokri, Mohd. Naif Hanis“.... This research project focusing on evaluating the Zn-Al-Mg alloy coated on steel wire rod. Prior to Zn-Al-Mg...”
Published 2017
Get full text
Thesis -
7
-
8by Mohamed Jamil, Fariza“... investigated using Ti-48Al, Ti-48Al- 2Cr, Ti-48Al-4Cr and Ti-48Al-8Cr (at. %) alloys. In the Ti-48Al alloys...”
Published 2012
Get full text
Thesis -
9by Rosli, Mohd. Aidil“... will investigate effects of the CMP parameters on the NiP/Al substrate by using Design of Experiment (DOE) approach...”
Published 2014
Get full text
Thesis -
10by Kamsir, Abdul Sukur“...This study investigates the wire electrical discharge machining (WEDM) of Ti- 48Al intermetallic...”
Published 2006
Get full text
Thesis -
11by Rahem, Monaf Ali“... for the deposition of EPD TiO2 nanostructured films Al2O3 use of new agents to disperse . Copper has good corrosion...”
Published 2014
Get full text
Thesis -
12
-
13by Rashiddy Wong, Freddawati“...Al-4V had been drilled using different drill point geometry under various cutting speeds and feed...”
Published 2008
Get full text
Thesis -
14
-
15by Chai, Teck Chaw“... of brittle intermetallic of Fe–Zn; whilst single layer Zn–0.5 wt% Al alloy coating has a poor adhesion due...”
Published 2014
Get full text
Thesis -
16by Razavykia, Abbas“... as modifier on machinability of Al-20%Mg2Si. The classical experimental design was also applied to develop...”
Published 2014
Get full text
Thesis -
17
-
18by Saud, Safaa Najah“... alloys are successfully being used. Among copper-based SMAs, Cu-Al-Ni alloys are used in a wide range...”
Published 2014
Get full text
Thesis -
19
-
20